Sniper & Sharpshooter Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
There are a lot of reviews on the net about the above die. I have not been able to find mention of just how far the die inserts the bullet in the case.

The instructions say to apply enough expansion (which is probably more then I use) to hold the bullet.

If you were to take the case out of the press and turned it upside down would the bullet fall out?

I use an “M” die and I set it so I can “snap” the bullet in place.

Anybody that uses one I would like to know your experience.

Thanks

Tom
 

·
Registered
Joined
·
13 Posts
Discussion Starter #2
Never mind. Saw a review said the instructions stated expand to .385.
No thanks
 
1 - 2 of 2 Posts
Top