Sniper & Sharpshooter Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter #1
Somehow, during my mixing, I ended up with a weight ratio of 27:1 when bedding my rifle yesterday but didn't realize it until after about an hour. Yeah, I know, I'm a DUMBASS! I decided to just let it sit and see what it looked like this morning before work and to my surprise, it was hard! I checked a blob of it I left on the bench and it was hard to the touch but I was able to crush thru it with a screwdriver tip. I know how I goofed this up but was wondering if it is not completely cured after the removal of the action what are my options for removing it completely to do it all over again? Thanks in advance for your input.
 

·
Registered
Joined
·
67 Posts
Discussion Starter #2
So I know I have to remove the Devcon and start all over but want input on, or experiences on removing the Devcon from the stock COMPLETELY? Anybody?
 

·
Registered
Joined
·
4 Posts
Dremel tool, lots of metal grinding bits, shop vac with good paper filter, respirator, good lights, and patience. Kinda been there before. It sucks.
 
1 - 3 of 3 Posts
Top