Sniper & Sharpshooter Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
This is Warrior6372, a new member of the forum. In my personal intro message, I stated that I was having a problem removing a single-point safety so as to install an ambi. Well, I figured out that I had to remove the trigger and hammer pins on my drop-in trigger and then wiggle the trigger within the receiver along with moving the safety around, and then finally the old safety came out. The exchange was made; I am all set.
 
1 - 2 of 2 Posts
Top